24 hour

Attention over time

7-day rolling share of analyzed posts/comments mentioning this entity · 90 daily points ending 2026-10-16

Final complete day: 2026-10-16. Attention was 0.1% — this entity appeared in 9 of 12,303 analyzed posts/comments in the seven days ending that day (10 mentions).

Each point is a seven-day rolling window of complete UTC days; a point is comparable only when at least 100 analyzed posts or comments fall inside it. A day with no analyzed records counts as zero; missing coverage is marked and never shown as zero. The series ends at the latest complete analyzed day — it never extends into the current incomplete day. How attention is measured.

Recent mentions

1. 2026-10-16 01:34 UTCComment

   !remindme 24 hours

2. 2026-10-15 14:05 UTCComment

   Ok I snipped off a fresh section of filament and put it in my dryer at 80C yesterday. It's been in there for over 24 hours now and it's still pliable. 🤷

3. 2026-10-15 07:25 UTCComment

   Some subreddit hide the downvotes for 24 hours to prevent the downvote sheep bully someone

4. 2026-10-14 16:08 UTCComment

   Not true. The ratings are for how the chairs will hold up, not for actual comfort. It’s meant for chairs used in business settings. A four hour chair is meant for short tasks like an occasional meeting. If sat in longer, or at a higher frequency, the chairs warranty is effectively void. The foam will flatten out permanently, the piston will fail from multiple adjustments from different people, etc. This is why some chairs are rated 12 or even 24 hours. These chairs are meant for stuff like airport traffic controllers, etc.

5. 2026-10-14 00:02 UTCPost

   HIPS brittle - I'm running HIPS as support material for ABS in my Vision Miner 22 IDEX V4 and it keeps becoming brittle and cracking inside the extruder and PTFE tubes. I've tried two brands, Gizmo Dorks from Amazon and 3DXTech from McMaster and both have turned to shit. The Gizmo Dorks was able to print about 1/3kg before I switched to the 3DX which lasted only a single 24 hour print and then cracked. The only information I can find online about the cause of embrittlement is chemical contamination (which is not the case here) and UV exposure which I don't think is likely, especially considering one of the rolls failed after just 24 hours. Are there any alternative materials that will work as breakaway support for ABS? I am hesitant to try another brand of HIPS to see if it's any different because this is my work printer and I already wasted a week on one print just from clearing jams and restarting, but if there is a surefire method of keeping the filament pliable then I am open to suggestions. Due to the 22 IDEX's construction, the spool holders are inside the heated enclosure - which I am running at 80C. Is heat what's causing the embrittlement? If so, I can reconfigure the PTFE tubes and feed the spool from outside the machine, although I have not had any issues with the ABS.