glass

Attention over time

7-day rolling share of analyzed posts/comments mentioning this entity · 90 daily points ending 2026-09-01

Final complete day: 2026-09-01. Attention was 0.2% — this entity appeared in 32 of 17,943 analyzed posts/comments in the seven days ending that day (53 mentions).

Each point is a seven-day rolling window of complete UTC days; a point is comparable only when at least 100 analyzed posts or comments fall inside it. A day with no analyzed records counts as zero; missing coverage is marked and never shown as zero. The series ends at the latest complete analyzed day — it never extends into the current incomplete day. How attention is measured.

Recent mentions

1. 2026-09-01 16:15 UTCComment

   I use these for everything even glass as well.

2. 2026-09-01 15:27 UTCComment

   I would design the side that stick to the glass completely flat and that's the side you print down. Then the bottom part angle it so that the over hang is very minimal and it can build on itself. 45⁰ or less. Or if you want you can do this and print it straight up and down H. So that the H part is laying on the bed and you can only get as long as your print bed is high.

3. 2026-09-01 15:10 UTCComment

   Haven’t used a scraper in like 8 years, since flexible spring steel build plates became the norm. What are people using these for? Are people out there still printing on glass?

4. 2026-09-01 14:24 UTCComment

   In the 10ish years I've owned a printer I have never, NEVER used a metal scraper or knife on my build plate. I get it if it's glass but for any Pei or textured surface you're just destroying the plate.

5. 2026-09-01 11:57 UTCComment

   Nice, vase mode with a stretched profile is a clean way to do it. One idea if you get any hotspots showing through: go slightly bigger on the diameter so there's more air gap between the shade and the glass. That extra distance evens out the glow a lot. Alternatively you could scale it enough that the shade covers the glass cylinder entirely rather than sitting close to it, which hides the light source completely and gives you a softer, more uniform surface.