nozzle

Attention over time

7-day rolling share of analyzed posts/comments mentioning this entity · 90 daily points ending 2026-09-01

Final complete day: 2026-09-01. Attention was 2.2% — this entity appeared in 394 of 17,943 analyzed posts/comments in the seven days ending that day (527 mentions).

Each point is a seven-day rolling window of complete UTC days; a point is comparable only when at least 100 analyzed posts or comments fall inside it. A day with no analyzed records counts as zero; missing coverage is marked and never shown as zero. The series ends at the latest complete analyzed day — it never extends into the current incomplete day. How attention is measured.

Recent mentions

1. 2026-09-01 23:12 UTCPost

   Scratching plates - Hello all, I’m currently having issues with my Centauri Carbon Gen1. It currently has about 300 hours on it and I’ve been through 3 plates. It just keeps scratching them to death, assuming it’s the Z axis or something along those lines that it isn’t reading right. I auto level EVERY print. I’m not sure what to do now. I’ve replaced the nozzle but I don’t exactly have the money to keep throwing at it. Any ideas on what I should do?

2. 2026-09-01 21:49 UTCComment

   More purge. If the nozzle hasnt fully cleared out the old color after switching, obviously you are going to get mixed colors

3. 2026-09-01 21:41 UTCPost

   My tallest print so far - I bought this secondhand Anycubic Kobra 2 Max. And it had several issues, although some were Anycubic Slicer issues and me learning it. I found this printer to be a bit unreliable with its auto levelling and z-offset settings. It also had a nozzle and hot end clog. An issue where a slicer update reset some of my saved settings. And the z-offset needed to he changed if there was no raft or brim layer. But all that is solved and now I am looking forward to printing long and big objects. Any prop gurus managed to work out what this piece is from?

4. 2026-09-01 21:03 UTCPost

   Need help with gaps in outer walls. - I’m few months into 3d printing with Centauri carbon 2. I’ve troubleshoot few things and just as I thought I begin to get a grip on basics I run into the issue where at the beginning of a new outside wall it looks like the plastic is starting being extruded few millimetres after it should have been This exclusively happens a the the beginning of the wall. I recalibrated everything, the filament is dry and I played around with setting but can’t even begin to make faults smaller. I’m printing PLA 200, 195 (tried higher temps), 0.6 nozzle, 0.8 retraction (tried multiple values), 0.99 extrusion, 0.3 pressure advance (again tried many values). Where do I even begin to look?

5. 2026-09-01 20:35 UTCComment

   If it is then let me know, I've had mine set all the way to 0.7, with a 0.6 nozzle though but still, the elephant's foot is quite absurd. Mind you that was after calibrating z offset, first layer height, line width and flow.