sand

Attention over time

7-day rolling share of analyzed posts/comments mentioning this entity · 90 daily points ending 2026-10-16

Final complete day: 2026-10-16. Attention was 0.1% — this entity appeared in 13 of 12,303 analyzed posts/comments in the seven days ending that day (28 mentions).

Each point is a seven-day rolling window of complete UTC days; a point is comparable only when at least 100 analyzed posts or comments fall inside it. A day with no analyzed records counts as zero; missing coverage is marked and never shown as zero. The series ends at the latest complete analyzed day — it never extends into the current incomplete day. How attention is measured.

Recent mentions

1. 2026-10-16 18:04 UTCComment

   Might need a little more post-processing. I've done a little bit of this, it's not my favorite thing, but a few tricks I have learned that can help. Sanding: Not really a trick, but it's often necessary to get the surface finish you want. Can be difficult with weird geometry to get into weird geometry. for tighter spaces I would recommend a small rotary tool. My current favorite there is the Fanttic F2 Master. Filling: Wood putty! The stuff I have been using is called Dap Plastic Wood. It comes in a can and a squeezable tube. Use in a well ventilated area, gloves are probably recommended. This stuff is great for filling in gaps and seams. Sand the area where you want to apply it first because it helps it to stick. Smear it on, don't try to do multiple applications at once because it can ball up and come back off. It's going to be a little messy. Smear it on and let it set. Once it is hardened you can sand it down. Places like under the chin on your print would be a good spot to use this. Filler primer: Spray on automotive filler primer can hide .2mm layer lines sometimes just in a single coat. As with above methods, you want to apply a layer, let it cure and sand a bit. Additional applications may be needed to fully hide surface blemishes. Super glue (CA Glue) and baking soda: This is sort of the quick and easy way out for small blemishes. Probably not the best, but it works. Put down some CA glue where the gap is, I like the gel-thick stuff made by Gorilla because it stays where you put it. With gloves on, smear it around to fill whatever gaps you're trying to hide, then dust it with some baking soda. This makes the CA cure faster because it acts as an alkaline catalyst. Because it accelerates the glue curing, it can also generate significant heat. I definitely recommend doing a few tests on scrap material if you want to try this method just to make sure it won't soften your print when it heats up. As always, sand and reapply to get the desired result.

2. 2026-10-16 00:30 UTCComment

   Filler primer, sand paper, primer, sand, primer, sand, repeat.

3. 2026-10-15 23:50 UTCComment

   Sand prime sand prime sand

4. 2026-10-15 23:47 UTCComment

   You probably need to get some filler primer, put on a few light coats until lines are gone. Then sand.

5. 2026-10-15 23:26 UTCComment

   Sand as much as possible before going into a few layers of an acetone bondo mix and then filler primer it