window

Attention over time

7-day rolling share of analyzed posts/comments mentioning this entity · 90 daily points ending 2026-10-16

Final complete day: 2026-10-16. Attention was 0.2% — this entity appeared in 25 of 12,303 analyzed posts/comments in the seven days ending that day (29 mentions).

Each point is a seven-day rolling window of complete UTC days; a point is comparable only when at least 100 analyzed posts or comments fall inside it. A day with no analyzed records counts as zero; missing coverage is marked and never shown as zero. The series ends at the latest complete analyzed day — it never extends into the current incomplete day. How attention is measured.

Recent mentions

1. 2026-10-16 23:54 UTCComment

   I am not sure if the headaches where caused by the printing. Kind of a joke. But I was running it 24/7 with not much air circulation :P So it might be :O So this is not a setup for printing with ABS or other very toxic filaments. But more a setup to get some fresh air in without opening a window and getting a big draft. In the future I prolly will make an enclosure for the printer and connect this fan to it. So I can print those extra poisonous prints. :D

2. 2026-10-16 18:43 UTCComment

   If your apartment has basements for storage with electricity, I would strongly suggest putting it down there and if it has a window, venting it right out there, when the printer says done, don’t go down there until 30 minutes have passed

3. 2026-10-16 16:37 UTCComment

   Looking at your setup, move it away from the window, put the piece on the diagonal, and print slower should all help significantly. Printers (especially bed slingers) have a hard time maintaining consistent heat at the edges of the build plate. Similarly, part of the problem with warping is that the ambient temp is much cooler than the build plate, so you want to maintain a warm environment in the room it is in.

4. 2026-10-16 16:16 UTCComment

   Check out these swappable led lights. You print the frame for either a window or the $3 led board. We have seasonal, superhero and most sports

5. 2026-10-16 15:09 UTCComment

   Usually just stay out of the basement and crack a window. I use ASA pretty rarely for when I know something is going to be outside and structural, so I'll often go months without messing around with it. But I can definitely print it just fine without a heated chamber.