x2d

Attention over time

7-day rolling share of analyzed posts/comments mentioning this entity · 90 daily points ending 2026-09-01

Final complete day: 2026-09-01. Attention was 0.2% — this entity appeared in 39 of 17,943 analyzed posts/comments in the seven days ending that day (43 mentions).

Each point is a seven-day rolling window of complete UTC days; a point is comparable only when at least 100 analyzed posts or comments fall inside it. A day with no analyzed records counts as zero; missing coverage is marked and never shown as zero. The series ends at the latest complete analyzed day — it never extends into the current incomplete day. How attention is measured.

Recent mentions

1. 2026-09-01 19:58 UTCComment

   Print PLA with door open! Otherwise filament (partially in that case) clogs in nozzle because of no cooling on cold zone of unused hotend so heat creep happens. Restoring flow of the filament and cooling fan eliminate the issue. That's my experience with X2D

2. 2026-09-01 15:52 UTCPost

   Support spaghetti failure - Hey all, This is my first time trying to do a print with support trees, using my X2D. The primary is PLA +, with supports from an external roll of PETG. This is the second time this particular print failed in the same way. Just from looking at it, it almost appears as though the PETG and PLA are getting mixed somehow? Can anyone with more experience provide some insight on what might be going on here? Thanks!

3. 2026-09-01 04:25 UTCComment

   Printing in an X2D Main nozzle - Bamboolab AMS TPU Right nozzle - PLA Auto selected bamboo studio for slicing Printed face down so the supports were on the inside to leave a cleaner finish on the back Fist time printing TPU

4. 2026-09-01 03:50 UTCPost

   Love how the lights of my X2D make this striking beam effect against the wall - My first 3D printer!! Currently drying out my filaments that I bought used so waiting for a bit before printing benchy!

5. 2026-08-31 19:18 UTCPost

   Fixing surface finished with insignia matte pla - I'm currently printing the Endeavour space shuttle a on my X2D with the high quality .16mm setting and ran out of Bambu White PLA Basic so I decided id switch to a matte material instead for this project and picked up some Insignia Matte PLA from Best Buy (which I’ve heard is essentially rebranded Polymaker/PolyTerra) thinking the matte finish would look great on a large model. As you can see in the photo, the left part (Bambu Basic) has a smoother surface finish compared to the Insignia Matte on the right. Here’s what I already had calibrated for the Insignia Matte before starting the print: **Temperature:** 210–215°C (via temp tower) **Flow Dynamics (PA):** K-factor of 0.019 For some reason I didn't do flow rate calibration before printing but after this print I did it and got the following for the two calibration stages. **Flow Rate:** 0 on stage One, -1 on stage Two Is there anything else I should look into to smooth this out or should I test with just the slight flow rate change? Thanks for any suggestions.