outlet

Attention over time

7-day rolling share of analyzed posts/comments mentioning this entity · 90 daily points ending 2026-08-14

Final complete day: 2026-08-14. Attention was 1.5% — this entity appeared in 95 of 6,299 analyzed posts/comments in the seven days ending that day (162 mentions).

Each point is a seven-day rolling window of complete UTC days; a point is comparable only when at least 100 analyzed posts or comments fall inside it. A day with no analyzed records counts as zero; missing coverage is marked and never shown as zero. The series ends at the latest complete analyzed day — it never extends into the current incomplete day. How attention is measured.

Recent mentions

1. 2026-08-14 17:32 UTCComment

   We installed one when we added a bathroom. I‘ll never be without one again. We plugged ours into a WiFi enabled outlet. It runs for 2 minutes at 6:30 am, 6 pm, and 9:30 pm when we know we’re going to want hot water in the bathroom and the outlet app has a shortcut for when I want to take a shower.

2. 2026-08-14 15:22 UTCComment

   Yes, you can add power under the sink, but I wouldn't turn the dishwasher's single outlet into a splitter without checking the circuit. Before worrying about the drain line, have an electrician check the existing circuit and add an accessible receptacle if local rules allow it. That's how I handled power for my Viomi Vortex 6 Pro. The purifier's load wasn't the hard part; the existing circuit and legal outlet location were.

3. 2026-08-14 00:37 UTCComment

   You check that it wasn’t the outlet?

4. 2026-08-13 17:58 UTCComment

   I cannot use a stud finder, my body triggers them continuously. As for the outlet, 1. take off the cover 2. use a toothpick (or small insulated screwdriver) to locate which side of the receptacle the stud is located. Note, it might be neither of the receptacle is an “old work” box. 3. check at the typical 16 inch spacing. 4. if this is over a fireplace, it could be 24 inch spacing. 5. use the smallest possible drill bit to locate the stud, drill at approx 1” increments and patch later. Good luck from another unlucky stud finder user.

5. 2026-08-13 15:52 UTCComment

   check to see if you have a GFI OUTLET (With push to reset" button in the center). These are by code, often daisy-chained together involving several outlets on the one circuit.bIn a mobile home, they're usually found in the kitchen and the bathroom(s).